Troubleshooting
First, check to make sure that your fuse is intact. This is the large blue fuse in the lower-left hand corner of the RAMBo card. Simply pull it out, and c...
Mon, 14 Jul, 2014 at 6:29 PM
The Phoenix uses timing belts on all its axes, so you should not usually need to replace belts unless they were mis-cut here at Ez3D. However, if excessive...
Mon, 22 Sep, 2014 at 11:19 PM
The Ez3D software only works with Ez3D firmware. Installing any other firmware will prevent the software from ever discovering your printer. If you re-fla...
Fri, 28 Nov, 2014 at 1:02 PM